Eutectic Gallium‐Indium (EGaIn): A Liquid Metal Alloy for the Formation of Stable Structures in Microchannels at Room Temperature
Michael David Dickey, Ryan C. Chiechi, Ryan J. Larsen, Emily A. Weiss, David A. Weitz, George M. Whitesides
Harvard University
阅读操作
确认中在文库中上传 PDF 后可生成中文音频讲解。
摘要与影响
This paper describes the rheological behavior of the liquid metal eutectic gallium‐indium (EGaIn) as it is injected into microfluidic channels to form stable microstructures of liquid metal. EGaIn is well‐ ;suited for this application because of its rheological properties at room temperature: it behaves like an elastic material until it experiences a critical surface stress, at which point it yields and flows readily. These properties allow EGaIn to fill microchannels rapidly when sufficient pressure is applied to the inlet of the channels, yet maintain structural stability within the channels once ambient pressure is restored. Experiments conducted in microfluidic channels, and in a parallel‐plate rheometer, suggest that EGaIn's behavior is dictated by the properties of its surface (predominantly gallium oxide, as determined by Auger measurement s); these two experiments both yield approximately the same number for the critical surface stress required to induce EGaIn to flow (∼0 .5 N/m). This analysis–which shows that the pressure that must be exceeded for EGaIn to flow through a microchannel is inversely proportional to the critical (i.e., smallest) dimension of the channel–is useful to guide future fabrication of microfluidic channels to mold EGaIn into functional microstructures.
逐年被引趋势
关键指标
同类平均 = 1
同领域 · 同年份 · 同类型
Google Scholar 与 OpenAlex 的被引统计范围不同,数值存在差异属正常。
AI 辅助阅读
依据:摘要
可就本文提问;依据不足时会说明。
学术脉络
学科主题
工程Electrowetting and Microfluidic Technologies
Fluid Dynamics and Heat Transfer · Thermodynamic and Structural Properties of Metals and Alloys
参考文献 16
此处列出前 3 条
引用本文 1,594
按被引量排序,此处列出前 3 条