Programming Film‐Formation Kinetics via Photoinduced Acceptor Oligomerization for Efficient and Stable Organic Solar Cells
Wenjun Zhang, Lingya Sun, Tongtong Yang, Huajun Xu, Zhiming Zhou, Shengnan Liu, Qidi Zhang, Yuanyuan Kan 等 16 位
Shandong University Harbin Engineering University Shenzhen Technology University Jianghan University
阅读操作
确认中在文库中上传 PDF 后可生成中文音频讲解。
摘要与影响
Precise control over the solution‐to‐solid transition is essential for high‐performance organic solar cells (OSCs), yet the rapid crystallization of Y‐series acceptors severely narrows the morphology‐optimization window. Here, we develop a photoresponsive thioctic acid‐functionalized acceptor, L8‐TA, whose photoinduced pre‐oligomerization was systematically optimized to generate Oli‐L8‐TA prior to film formation. When used as a low‐content third component in D18:L8‐BO, Oli‐L8‐TA regulates host crystallization through favorable compatibility with L8‐BO and steric confinement from the oligomeric structure, extending the crystallization window from 152 to 273 ms while enhancing molecular ordering. The optimized blend microstructure exhibits a favorable vertical phase distribution, contributing to improved charge transport and reduced recombination. Consequently, ternary devices achieve a PCE of 20.12% with a fill factor (FF) of 81.31%. Device stability is also enhanced, with extrapolated T 80 lifetimes extended from 490 to 905 h under continuous illumination and from 448 to 750 h at 65°C. These results demonstrate that photoinduced pre‐oligomerization provides a direct molecular‐state handle for programming host crystallization kinetics and optimizing active‐layer morphology during the solution‐to‐solid transition in OSCs.
逐年被引趋势
暂无年度引用数据
关键指标
同类平均 = 1
同领域 · 同年份 · 同类型
Google Scholar 与 OpenAlex 的被引统计范围不同,数值存在差异属正常。
AI 辅助阅读
依据:摘要
可就本文提问;依据不足时会说明。
学术脉络
学科主题
工程Organic Electronics and Photovoltaics
Organic Light-Emitting Diodes Research · Block Copolymer Self-Assembly