Design model for composite beam‐to‐reinforced concrete wall joints
José Henriques, Luís Simões da Silva, Isabel Brito Valente
University of Coimbra University of Minho
阅读操作
确认中在文库中上传 PDF 后可生成中文音频讲解。
摘要与影响
A design model for composite beam‐to‐reinforced concrete wall joints is presented and discussed in this paper. The model proposed is the component method extended to this type of joint. The characterization of the active components is therefore performed in terms of force‐deformation curves. In this type of joint, special attention is paid to the steel‐concrete connection where “new” components, not covered in EN 1993‐1‐8, are activated. The application of the model allows the designer to obtain the joint properties in terms of the moment‐rotation curve. The accuracy of the proposed model is verified by comparing it with available experimental and numerical results. The latter were developed in the FE program ABAQUS and previously validated by experimental results.
逐年被引趋势
关键指标
同类平均 = 1
同领域 · 同年份 · 同类型
Google Scholar 与 OpenAlex 的被引统计范围不同,数值存在差异属正常。
AI 辅助阅读
依据:摘要
可就本文提问;依据不足时会说明。
学术脉络
学科主题
工程Structural Load-Bearing Analysis
Structural Behavior of Reinforced Concrete · Seismic Performance and Analysis
参考文献 13
此处列出前 3 条
引用本文 6
按被引量排序,此处列出前 3 条