Research on design and cutting performance of gradient helix edge end mill
Mingna Ding, Xianli Liu, Caixu Yue, Mengchao Fan, Wei Xia
Harbin University of Science and Technology
阅读操作
确认中在文库中上传 PDF 后可生成中文音频讲解。
摘要与影响
There are inequable force-induced deformation, obvious cutting vibration problems during side milling of low-rigidity frame and beam parts, resulting in unsatisfactory dimensional accuracy and surface quality. Most of these parts are side-milled by end mill, which currently in use do not take into account the workpiece stiffness imparity. Therefore, the concept of Gradient Helix Edge (GHE) is proposed in this research and its advantages are analyzed. The general mathematical model is given. And the parabola is taken as an example for the GHE space equation derived, of which accuracy is verified by numerical simulation. Finally, The comparison experiment with the invariant helix edge end mill was completed. The results showed that the milling force perpendicular to the milling surface of the GHE end mill was smaller and less fluctuation, which could obtain less force-induced deformation theoretically. The milling process was smoother, and better surface quality was obtained. The excellent performance of the GHE end mill was further verified by milling different features.
逐年被引趋势
关键指标
同类平均 = 1
同领域 · 同年份 · 同类型
Google Scholar 与 OpenAlex 的被引统计范围不同,数值存在差异属正常。
AI 辅助阅读
依据:摘要
可就本文提问;依据不足时会说明。
学术脉络
学科主题
工程Advanced machining processes and optimization
Engineering Technology and Methodologies · Advanced Numerical Analysis Techniques
参考文献 24
此处列出前 3 条
引用本文 12
按被引量排序,此处列出前 3 条