Experimental Study on Seismic Performance of Prefabricated Beam Wall Out-of-Plane Connection Nodes with Different Anchoring Measures
Meng Xian-hong, Keyu Liu, Zongqi Li, Liankai Sha
Shenyang Jianzhu University
阅读操作
确认中在文库中上传 PDF 后可生成中文音频讲解。
摘要与影响
In this paper, when the core tube structure of the fabricated frame core tube is thin and the horizontal anchorage length of the longitudinal reinforcement on the upper part of the beam is insufficient, when the beam-wall is connected by a sleeve, the seismic performance test of the nodes with different mechanical anchoring measures is carried out. The seismic performance of the anchored reinforced fabricated beam-wall out-of-plane connection node is studied by considering factors such as wall top axial compression, constraints, etc., under the same reinforcement ratio, one cast-in-place specimen and two are prefabricated with different anchoring measures. The effects of different anchoring measures on the energy dissipation capacity, stiffness, ductility and ultimate flexural capacity of the fabricated beam-wall joint under the condition of low-cycle reciprocating load applied to the beam end are studied. The research results show that the anchoring performance of the fabricated specimens with anchor plate measures for anchoring reinforcement has been greatly improved. When the bearing capacity meets the requirements, the stiffness and ductility are also significantly improved compared with other specimens. When the load is controlled, the plastic hinge is formed at the joint of the beam end, and the anti-side movement ability is obviously better than the 90° hook anchoring method. It fully shows that when the horizontal anchoring length is insufficient, the anchoring strengthening measures can improve the force performance of the nodes and avoid the occurrence of pull-off failure.
逐年被引趋势
关键指标
同类平均 = 1
同领域 · 同年份 · 同类型
Google Scholar 与 OpenAlex 的被引统计范围不同,数值存在差异属正常。
AI 辅助阅读
依据:摘要
可就本文提问;依据不足时会说明。
学术脉络
学科主题
工程Seismic Performance and Analysis
Structural Behavior of Reinforced Concrete · Structural Load-Bearing Analysis