A novel cold wire gas metal arc (CW-GMA) process for high productivity additive manufacturing
Chong Wang, Jun Wang, João B. Bento, Jialuo Ding, Gonçalo Pardal, Guangyu Chen, Jian Qin, Wojciech Suder 等 9 位
Cranfield University
阅读操作
确认中在文库中上传 PDF 后可生成中文音频讲解。
摘要与影响
Wire-arc directed energy deposition (DED) is suitable for depositing large-scale metallic components at high deposition rates. In order to further increase productivity and efficiency by reducing overall manufacturing time, higher deposition rates are desired. However, the conventional gas metal arc (GMA) based wire-arc DED, characterised by high energy input, normally results in high remelting and reheating at relatively high deposition rates, reducing the process efficiency and deteriorating the mechanical performance. In this study, a novel wire-arc DED process with the combination of a GMA and an external cold wire, namely cold wire-gas metal arc (CW-GMA), was proposed for achieving high deposition rate and low material remelting. The maximum deposition rates at different levels of energy input were investigated, with the highest deposition rate of 14 kg/h being achieved. An industrial-scale component weighing 280 kg was built with this process at a high deposition rate of around 10 kg/h, which demonstrated the capability of the process for high productivity application. It was also found that, due to the addition of the cold wire, the remelting was reduced significantly. The working envelope and geometric process model for the CW-GMA process was developed, which can be used to avoid defects in parameter selection and predict the geometry of single-pass wall structures. Moreover, the addition of the cold wire in the CW-GMA process reduced the specific energy density, leading to a reduction in both grain size and anisotropy, which improved the mechanical properties with increased strength and reduced anisotropy.
逐年被引趋势
关键指标
同类平均 = 1
同领域 · 同年份 · 同类型
Google Scholar 与 OpenAlex 的被引统计范围不同,数值存在差异属正常。
AI 辅助阅读
依据:摘要
可就本文提问;依据不足时会说明。
学术脉络
学科主题
工程Additive Manufacturing Materials and Processes
Welding Techniques and Residual Stresses · Additive Manufacturing and 3D Printing Technologies
参考文献 36
此处列出前 3 条
引用本文 70
按被引量排序,此处列出前 3 条