Explosion of a refinery reactor vessel due to hindered thermal shrinkage leading to bulging and strain aging
Christian Klinger, Dirk Bettge, Tobias Mente, Ralf Häcker, Matthias Ell
Federal Institute For Materials Research and Testing
阅读操作
确认中在文库中上传 PDF 后可生成中文音频讲解。
摘要与影响
A large explosion occurred at an oil refinery after a desulfurization reactor cracked, releasing hot, pressurized gasoline. The resulting explosions and fire caused extensive damage and injured some employees. A 1.4 m crack adjacent to a weld seam at a reactor support bracket caused the release. The reactor shell exhibited distinctive circumferential bulging. The reactor was erected using mild steel. All material properties of the reactor shell complied with the regulations in effect at that time. Fractographic analysis of the main crack and smaller ones at the other support brackets revealed stepwise ductile fracture resulting from static loading. All well-known failure mechanisms for pressure vessel burst had proven wrong: overpressure, pressure cycles, overtemperature, creep, corrosion, external (cyclic) mechanical loads… Due to small spherical indentations on the inside of the reactor shell, a completely new failure mechanism was established and investigated: During service, the reactor was partially filled with ceramic ball grading and catalyst. Gasoline was processed at 150–250 °C and ∼ 24 bar. Each of the reactor’s ∼ 20 operating cycles ran for several months until the catalyst was spent, after which the reactor was cooled, depressurized, emptied, and refilled. Upon heating, the thermal expansion of the steel shell (∼3 times greater than ceramic) created gaps that were filled as ceramic balls settled. During operation, the catalyst degraded and agglomerated with the ceramic balls, forming a rigid mass. Upon cooling, the rigid mass resisted the vessel’s thermal contraction, inducing circumferential tensile stresses and plastic deformation, resulting in permanent bulging of the vessel. Charpy impact energy near the welds was significantly reduced, attributed to thermal and strain aging in the bulged region. Progressive embrittlement and increasing plastic strain led to crack initiation and incremental ductile crack propagation at the support bracket welds over successive cycles. The fracture features were reproduced in laboratory tests at 200 °C. FEA analysis confirmed the proposed mechanism. Two identical vessels showed similar damage but had not yet failed. To prevent future damage in pressure vessels, this new failure mechanism needs to be incorporated into design, operating and inspection codes for pressure vessels possibly/partially filled with solids.
逐年被引趋势
暂无年度引用数据
关键指标
同类平均 = 1
同领域 · 同年份 · 同类型
Google Scholar 与 OpenAlex 的被引统计范围不同,数值存在差异属正常。
AI 辅助阅读
依据:摘要
可就本文提问;依据不足时会说明。
学术脉络
学科主题
工程Mechanical Failure Analysis and Simulation
Structural Integrity and Reliability Analysis · Material Properties and Failure Mechanisms
参考文献 7
此处列出前 3 条