Experimental investigation of leakage flow measurement and surface morphology in small-scale liquid mechanical seals
Shaolin Liu, Mohamed Amine Ben Abdelwahed, Alain Sommier, David Reungoat, Philippe Darnis
Centre National de la Recherche Scientifique Université de Bordeaux Arts et Métiers Institut de Mécanique et d'Ingénierie de Bordeaux
阅读操作
确认中在文库中上传 PDF 后可生成中文音频讲解。
摘要与影响
This study presents an experimental investigation into the fluid leakage behavior of small-scale liquid mechanical seals, with a focus on precise leakage flow characterization under controlled conditions. An advanced experimental platform was developed to simulate realistic operating conditions, including varying pressures and rotational speeds, enabling accurate assessment of fluid transport mechanisms in mechanical seals. The investigation involved detailed leakage flow rate measurements and surface roughness characterization for two types of seals: a worn seal (3000 h of industrial use) and a new, unused seal. Leakage flow rates were measured using a volumetric collection method to capture flow variations under controlled pressure (up to 12 bars) and rotational speed conditions (up to 6000 rpm). Non-contact surface roughness analysis was conducted using the AltiSurf 500 profilometer, providing 1D, 2D roughness profiles, and 3D surface reconstructions. Results indicate that the worn seal exhibited a lower average roughness (Ra = 0.08928–0.1397 μ m) compared to the new seal (Ra = 0.1203–0.2023 μ m). Despite this smoother surface, kurtosis (Rku) analysis revealed higher peak sharpness in the worn seal (Rku = 13.7611) versus the new seal (Rku = 6.5860), indicating localized surface peaks induced by prolonged operational wear. Leakage flow rate measurements revealed distinct trends. At a constant differential pressure of 4 bars, the worn seal exhibited unstable leakage flow at rotational speeds below 3000 rpm but stabilized at 12.0 mL/h (±0.5 mL/h) above this threshold. Under constant speed conditions (4000 rpm), leakage remained minimal at low pressure differentials ( < 1 bar) but increased significantly beyond 5 bars, marking a transition in leakage mechanisms. The new seal exhibited minimal leakage under all conditions, highlighting the strong correlation between surface evolution and leakage characteristics. These findings provide valuable insights into leakage flow measurement techniques and reveal the influence of surface morphology changes on fluid transport in mechanical seals. The results contribute to improved measurement methodologies and provide guidance for optimizing seal design in aerospace applications. • Experimental investigation of fluid leakage behavior in liquid mechanical seals. • High-pressure test rig (up to 12 bars, 6000 rpm) enabled controlled leakage analysis. • Surface roughness characterization identified key factors influencing leakage dynamics. • Worn seals showed increased leakage due to surface degradation and pressure effects. • Findings provide guidance for optimizing seal design and material selection.
逐年被引趋势
关键指标
同类平均 = 1
同领域 · 同年份 · 同类型
Google Scholar 与 OpenAlex 的被引统计范围不同,数值存在差异属正常。
AI 辅助阅读
依据:摘要
可就本文提问;依据不足时会说明。
学术脉络
学科主题
工程Tribology and Lubrication Engineering
Advanced machining processes and optimization · Tribology and Wear Analysis
参考文献 36
此处列出前 3 条
引用本文 5
按被引量排序,此处列出前 3 条