Extrusion-based 3D printing of food pastes: Correlating rheological properties with printing behaviour
Sicong Zhu, Markus Stieger, Atze Jan van der Goot, Maarten A.I. Schutyser
Wageningen University & Research
阅读操作
确认中在文库中上传 PDF 后可生成中文音频讲解。
摘要与影响
Development of 3D food printing applications requires in-depth knowledge on printing behaviour of food materials. In extrusion-based 3D printing, rheological properties of a recipe are critical to achieve successful printing. The objective of this research is to investigate potential correlations between printability of formulations and simple rheological properties. We used tomato paste as a model system to investigate the correlation between printing stability, dispensability and rheological properties. The results show a linear correlation between ingredient's flow stress, zero shear viscosity and corresponding printing stability. The extrusion pressure necessary to extrude tomato paste increased linearly with increasing flow stress. More experiments with other aqueous-based food formulations indicated that their printability aligned reasonably well with the correlation of tomato paste; however, for fat-based products different printing behaviour was observed. Finally, we propose a rational guideline for developing aqueous food recipes with desired printability based on flow stress measured by shear rheology.
逐年被引趋势
关键指标
同类平均 = 1
同领域 · 同年份 · 同类型
Google Scholar 与 OpenAlex 的被引统计范围不同,数值存在差异属正常。
AI 辅助阅读
依据:摘要
可就本文提问;依据不足时会说明。
学术脉络
学科主题
工程Additive Manufacturing and 3D Printing Technologies
Innovations in Concrete and Construction Materials · Rheology and Fluid Dynamics Studies