Influence of Mg content on microstructure and mechanical properties of lean (< 1 wt.%) powder-mixed Zn–Mg alloys processed by PBF-LB
Himesha Abenayake, R.J.W. Frost, Vitalii Shtender, Cecilia Persson, Francesco D’Elia
Uppsala University
阅读操作
确认中在文库中上传 PDF 后可生成中文音频讲解。
摘要与影响
Zinc (Zn) is a promising biodegradable implant material but suffers from insufficient strength and ductility. Although magnesium (Mg) alloying can improve these properties, Mg contents above 1 wt.% markedly reduce ductility due to excessive formation of brittle Mg 2 Zn 11 and MgZn 2 intermetallic phases, thereby limiting biomedical potential. Powder bed fusion–laser beam (PBF LB) enables microstructural control and design flexibility, making it suitable for fabricating patient-specific biomedical implants with complex structures. In this study, the influence of low Mg contents (x = 0.06, 0.5, and 1 wt.%) on the microstructure and mechanical performance of powder-mixed Zn–xMg alloys processed by PBF-LB is investigated, with a particular focus on identifying an optimal composition and processing window for biodegradable applications. Mg-driven microstructural changes are highlighted and contrasted with the conventional use of pre-alloyed powders, with all compositions reaching ¿ 99% relative density. Increasing Mg content was found to promote grain refinement and the formation of Mg 2 Zn 11 and MgZn 2 intermetallic phases, leading to a pronounced increase in yield and ultimate tensile strength but a concurrent reduction in elongation to failure. Among the investigated compositions, Zn–0.5Mg exhibited the most favourable combination of mechanical properties, with an average yield strength of 200 MPa and average elongation of 9%, and is therefore identified as a promising composition for biodegradable load-bearing applications. The composition–microstructure–property relationships established in this work provide a scientific basis for the rational development and optimisation of next-generation biodegradable Zn–based implant materials.
逐年被引趋势
暂无年度引用数据
关键指标
同类平均 = 1
同领域 · 同年份 · 同类型
Google Scholar 与 OpenAlex 的被引统计范围不同,数值存在差异属正常。
AI 辅助阅读
依据:摘要
可就本文提问;依据不足时会说明。
学术脉络
学科主题
工程Additive Manufacturing Materials and Processes
Magnesium Alloys: Properties and Applications · Powder Metallurgy Techniques and Materials