Effect of welding speed on the microstructure, mechanical and corrosion properties of 6061/7075 pulsed MIG welded joints
Shuai Li, Linjun Liu, Hongfeng Liu, Jie Yang, Chuanqing Liao, Xingxing Wang, Honggang Dong
North China University of Water Resources and Electric Power Dalian University of Technology
阅读操作
确认中在文库中上传 PDF 后可生成中文音频讲解。
摘要与影响
Pulsed metal inert gas welding (P-MIG) was performed on 6061-T6 and 7075-T6 aluminum alloys using ER5356 filler wire. With constant welding current and voltage, the influence of welding speed on the microstructure, mechanical properties, and corrosion behavior of the dissimilar joints was investigated. Tensile strength initially increased and then decreased with rising welding speed. It reached a peak value of 185.99 MPa at 500 mm/min, which is equivalent to 81.7% of the tensile strength of the 6061 base metal. Fracture occurred mainly in the heat-affected zone on the 6061 side and exhibited ductile fracture features. The microstructure and corrosion morphology of the joints were characterized using scanning electron microscopy (SEM), optical microscopy (OM), and electron probe microanalysis (EPMA). The weld zone was primarily composed of equiaxed dendrites, which gradually transitioned into coarse columnar grains toward the heat affected zone. AlFeMnSi intermetallic compounds were also identified. Due to compositional differences, the 7075 side of the dissimilar joint was more susceptible to intergranular, exfoliation, and electrochemical corrosion. The primary corrosion mechanism was attributed to galvanic corrosion between low-potential phases and the matrix. Corrosion behavior intensified with increasing welding speed. Considering both mechanical properties and corrosion resistance, the joint welded at 500 mm/min exhibited the most favorable overall performance.
逐年被引趋势
关键指标
同类平均 = 1
同领域 · 同年份 · 同类型
Google Scholar 与 OpenAlex 的被引统计范围不同,数值存在差异属正常。
AI 辅助阅读
依据:摘要
可就本文提问;依据不足时会说明。
学术脉络
学科主题
工程Welding Techniques and Residual Stresses
Advanced Welding Techniques Analysis · Aluminum Alloy Microstructure Properties