Impact fretting wear behavior of cemented carbide impact needle with surface modification
Shuiqing Liu, Haoran Xu, Jinyuan Fu, Silin Liu, Xu Han
Hebei University of Technology State Key Laboratory of Reliability and Intelligence of Electrical Equipment Changcheng Institute of Metrology & Measurement
阅读操作
确认中在文库中上传 PDF 后可生成中文音频讲解。
摘要与影响
• Rapid cooling of HCPEB refines the grains and transform the WC phase into the more wear-resistant WC 1-X phase. • RTS increase from 116 MPa to 506 MPa after HCPEB treatment. • Surface hardness of HCPEB-treated impact needle was 39% higher than that of untreated one. • A real finite element model of the WC-Co microstructure under SEM was established. High-current pulsed electron beam (HCPEB) treatment significantly enhances the wear resistance of WC-Co cemented carbide impact needles under high-frequency and micro-impact amplitude wear conditions, which are common in micro-nano mechanical systems. Quantitatively characterizing the effect of WC-Co on stress–strain relationships based on real microstructures and revealing the mechanisms of WC-Co surface modification by HCPEB treatment present certain challenges. Through modeling and experimental studies, the distribution of residual thermal stress (RTS) and the phase transition dependence under external stress on the wear resistance of HCPEB-modified WC-Co cemented carbide impact needles were quantified and resolved. It was discovered that HCPEB treatment reduces the proportion of recrystallization and recovery structures while increasing the content of grain deformation structures. The evolution of the stress field and microhardness along the depth of the microsurface reflects the adjustment process of HCPEB treatment on the microsurface properties of cemented carbide in the direction of electron incidence. Wear test results showed that after 300 million cycles, the wear volume of the impact needle treated with HCPEB was reduced by 71.4% compared to the untreated specimens, indicating that optimizing the wear resistance of materials by adjusting internal stresses to external loads and phase change processes is feasible.
逐年被引趋势
关键指标
同类平均 = 1
同领域 · 同年份 · 同类型
Google Scholar 与 OpenAlex 的被引统计范围不同,数值存在差异属正常。
AI 辅助阅读
依据:摘要
可就本文提问;依据不足时会说明。
学术脉络
学科主题
材料 / 化学Advanced materials and composites
Metal Alloys Wear and Properties · Surface Treatment and Residual Stress
参考文献 33
此处列出前 3 条
引用本文 5
按被引量排序,此处列出前 3 条