Kinetics of inter-fibre joint formation during hot-pressing of lignin-rich fibre networks
Amanda Mattsson, Gunilla Pettersson, José Luis Sanchez-Salvador, Per Engstrand, Ángeles Blanco, Carlos Negro, Mats Rundlöf, Hugo Hammar 等 12 位
Mid Sweden University Universidad Complutense de Madrid Karolinska Institutet KTH Royal Institute of Technology
阅读操作
确认中在文库中上传 PDF 后可生成中文音频讲解。
摘要与影响
Lignin-rich fibre networks offer a route to high-performance bio-based materials without synthetic binders, but the mechanisms governing strength development during hot-pressing are not fully understood. Here, chemi-thermomechanical pulp sheets were hot-pressed at 180–300 °C for 50 ms to 5 h at initial moisture contents of 7 and 25 wt.% to resolve the effects of pressing time, temperature, and moisture on strength development. Dry and wet specific strength and short-span compression were measured, and structural evolution was analysed by scanning electron microscopy and confocal fluorescence microscopy. Densification increased the number of inter-fibre contacts and mainly contributed to dry-strength development. However, improvement of both dry and wet strength was associated with the formation of load-bearing fibre–fibre joints under conditions consistent with lignin mobility and possible interdiffusion across fibre interfaces. Moisture accelerated this development by promoting fibre-wall softening, fibre conformability, and interfacial contact formation. At high temperatures and prolonged pressing times, thermal degradation limited further strength development. Master-curve analysis identified separate dry and moist pressing regimes, with apparent activation energies of approximately 220 and 90 kJ mol⁻¹, respectively. The results establish process–structure–property relationships for designing hot-pressing conditions in binder-free lignocellulosic materials within industrially relevant processing windows.
逐年被引趋势
暂无年度引用数据
关键指标
同类平均 = 1
同领域 · 同年份 · 同类型
Google Scholar 与 OpenAlex 的被引统计范围不同,数值存在差异属正常。
AI 辅助阅读
依据:摘要
可就本文提问;依据不足时会说明。
学术脉络
学科主题
材料 / 化学Lignin and Wood Chemistry
Material Properties and Processing · Wood Treatment and Properties