Electromechanical Performance of Strain Sensors Based on Viscoelastic Conductive Composite Polymer Fibers
Ziling Zhang, Mugaanire Tendo Innocent, Ning Tang, Ruyu Li, Zexu Hu, Mian Zhai, Lijun Yang, Wujun Ma 等 10 位
Donghua University State Key Laboratory for Modification of Chemical Fibers and Polymer Materials Nantong University
阅读操作
确认中在文库中上传 PDF 后可生成中文音频讲解。
摘要与影响
Flexible conductive polymer composite (CPC) fibers that show large changes in resistance with deformation have recently gained much attention as strain-sensing components for future wearable electronics. However, the electrical resistance of these materials decays with time during dynamic cyclic loading, a deformation performed to simulate their real application as strain sensors. Despite the extensive research on CPC fibers, the mechanism leading to this decay in the electromechanical response under repetitive cycles remains unreported. Herein, this behavior is investigated using fiber-based strain sensors wet spun from thermoplastic polyurethane (TPU) consisting of a carbonaceous hybrid conductive filler system of carbon black (CB) and carbon nanotubes (CNTs). We found electrical viscosity to predict the observed electromechanical resistance decay. This implies that cycling these materials enables the relaxation of both the polymer chains and the conductive network. In addition, the resulting piezoresistive fibers are sensitive to deformation in the region of low strain (gauge factor of 6.0 within 3.0% strain), remain conductive under 280.5% deformation, and are stable for more than 2000 cycles. Finally, we demonstrate the potential of TPU/CB-CNT fibers as strain sensors for monitoring human motion.
逐年被引趋势
关键指标
同类平均 = 1
同领域 · 同年份 · 同类型
Google Scholar 与 OpenAlex 的被引统计范围不同,数值存在差异属正常。
AI 辅助阅读
依据:摘要
可就本文提问;依据不足时会说明。
学术脉络
学科主题
工程Advanced Sensor and Energy Harvesting Materials
Carbon Nanotubes in Composites · Nanomaterials and Printing Technologies
参考文献 49
此处列出前 3 条
引用本文 66
按被引量排序,此处列出前 3 条