Effects of Reynolds number and texture dimensions on plastron stability of superhydrophobic surface with transverse grooves in turbulent flows
Shabnam Mohammadshahi, Foram S. Fanasia, Hangjian Ling
New Mexico State University University of Massachusetts Dartmouth
阅读操作
确认中在文库中上传 PDF 后可生成中文音频讲解。
摘要与影响
We experimentally studied the stability of the gas (or plastron) trapped on superhydrophobic surface (SHS) consisting of transverse grooves in turbulent flows. The experiments were conducted in a turbulent channel flow facility, where the channel height was 6.4 mm, the mean flow speed varied from 0.5 to 4.5 m/s, and the Reynolds number, based on mean flow speed and channel height, ranged from 3300 to 29 000. The 50 × 50 mm2 SHS was installed at the fully developed flow region. The status of the gas layer on the SHS was measured by reflected-light microscopy and bright-field microscopy. We found that as the Reynolds number increased, the SHS experienced a sudden wetting transition from the Cassie–Baxter state to the Wenzel state. A metastable state, where the liquid partially filled the grooves, was not observed, probably because the exposed surface textures acted as a rough wall and increased the near-wall turbulence. Furthermore, we found that the wetting transition occurred at a higher Reynolds number with decreasing texture gap, increasing texture height, and increasing texture width. For SHS with small texture heights, the experimentally measured critical Reynolds number for wetting transition agreed well with a theoretical model based on the balance between wall pressure fluctuations and surface tension at the gas–liquid interface. Our results enhance the fundamental understanding of SHS stability in turbulent flows and will guide the design of stable SHS for reducing turbulent drag.
逐年被引趋势
关键指标
同类平均 = 1
同领域 · 同年份 · 同类型
Google Scholar 与 OpenAlex 的被引统计范围不同,数值存在差异属正常。
AI 辅助阅读
依据:摘要
可就本文提问;依据不足时会说明。
学术脉络
学科主题
材料 / 化学Surface Modification and Superhydrophobicity
Fluid Dynamics and Turbulent Flows · Fluid Dynamics and Heat Transfer