Stable impact and contact force control by UAV for inspection of floor slab of bridge
Takahiro Ikeda, Shogo Yasui, Satoshi Minamiyama, Kenichi Ohara, Satoshi Ashizawa, Akihiko Ichikawa, Akihisa Okino, Takeo Oomichi 等 9 位
Meijo University Beijing Institute of Technology
阅读操作
确认中在文库中上传 PDF 后可生成中文音频讲解。
摘要与影响
This paper describes the contact force control on an unmanned aerial vehicle (UAV) developed to inspect the floor slabs of bridges. Our UAV is equipped with a three degree-of-freedom manipulator on top of the UAV body. To control the UAV for stable contact with the slab surface, the impact force should be considered. The impact force is modeled based on Hertzian contact stress. The control strategy of the UAV is cascade control separated into attitude control and position-force control. The attitude, position and force feedback are PID control. The force feedback is integrated into the position feedback seamlessly, and the output of the force feedback is added to the desired end-point position of the manipulator. This paper focuses on contact of the UAV and the floor slab. Therefore, the UAV is modeled considering the impact force in the vertical direction. The control method in the vertical direction is described, and then the altitude control and the contact force control are assessed. The altitude of the UAV was controlled with a 0.45 [sec] delay during ascending and 1.76 [sec] during descending. The UAV could control the contact force with mean error 1.61 ± 1.08 [N] while the desired contact force was 3 [N].
逐年被引趋势
关键指标
同类平均 = 1
同领域 · 同年份 · 同类型
Google Scholar 与 OpenAlex 的被引统计范围不同,数值存在差异属正常。
AI 辅助阅读
依据:摘要
可就本文提问;依据不足时会说明。
学术脉络
学科主题
工程Robot Manipulation and Learning
Teleoperation and Haptic Systems · Control and Dynamics of Mobile Robots
参考文献 28
此处列出前 3 条
引用本文 51
按被引量排序,此处列出前 3 条