Experimental Investigation of Airless Minimum Oil Lubrication for High-Speed Spindle Bearings
Jun Wang, Bela Lehnhardt, Volker Schneider, Defeng Lang, Koji KANEKO, Max Marian, Feliciano Greco
SKF (Netherlands) Leibniz University Hannover
阅读操作
确认中在文库中上传 PDF 后可生成中文音频讲解。
摘要与影响
:Frictional heat generation and lubricant starvation are major challenges in high-speed spindle bearings, where maintaining a stable oil film with minimal churning losses is critical for performance and durability. Conventional oil-air lubrication systems address this through continuous compressed-air supply which may result in high energy demand, increased noise, and added system complexity. This study presents a systematic experimental investigation of an airless minimum oil lubrication concept. To eliminate the need for compressed air, the investigated bearing-oiler system employs an integrated oil channel in the outer ring and a precision injection oiler capable of delivering micro volumes of oil close to the bearing contact zone. Systematic tests are carried out to examine the influence of key parameters (oil delivery position, flow rate, viscosity, and bearing speed) on bearing temperature, frictional torque, and oil film thickness. Results demonstrate stable operation up to 2.7 × 106 n · dm (n denotes the rotational speed in rpm and dm the bearing pitch diameter in mm), with stable temperature evolution and adequate film formation. Relative to oil-air lubrication, the airless approach achieves comparable thermal and tribological performance. The findings provide insight into the thermal and tribological behavior of airless minimum oil lubrication under high-speed bearing operating conditions.
逐年被引趋势
暂无年度引用数据
关键指标
同类平均 = 1
同领域 · 同年份 · 同类型
Google Scholar 与 OpenAlex 的被引统计范围不同,数值存在差异属正常。
AI 辅助阅读
依据:摘要
可就本文提问;依据不足时会说明。
学术脉络
学科主题
工程Tribology and Lubrication Engineering
Gear and Bearing Dynamics Analysis · Lubricants and Their Additives