Effect of laser surface texturing on tribological properties of polyimide composites in the application of traveling wave rotary ultrasonic motor
Xiaoliang Liu, Gai Zhao, Jinhao Qiu
Nanjing University of Aeronautics and Astronautics Lanzhou Institute of Chemical Physics
阅读操作
确认中在文库中上传 PDF 后可生成中文音频讲解。
摘要与影响
Purpose The purpose of this paper is to investigate the effect of laser surface texturing on the tribological properties of polyimide composites and the output performance of traveling wave rotary ultrasonic motor. Design/methodology/approach The surface texturing on polyimide composites specimens were fabricated by laser ablation process of different dimple densities, and then the tribological properties were tested by a flat-on-flat tribometer under dry conditions. Finally, the output performance of the traveling wave rotary ultrasonic motor was tested to verify the effectiveness of dimples surface texturing. Findings The results show that surface texturing can greatly enhance the friction coefficient of contact interface, especially the specimen with a dimple density of 7.06 per cent exhibited the highest friction coefficient among the specimens. When the input voltage is 500 V, the output power, locked-rotor torque and output torque of ultrasonic motor with textured PI of 7.06 per cent dimple density as friction material at the speed of 100 r/min increased by 13.8, 19 and 12.8 per cent compared to that of the untextured PTFE, respectively. When the ultrasonic motor reverses, the output performance is increased by 20.9, 40.3 and 17.7 per cent, respectively. Originality/value Surface texturing is an effective way to improve the friction behavior of polyimide composites and then correspondingly enhance the energy conversion efficiency and output performance of the traveling wave rotary ultrasonic motor.
逐年被引趋势
关键指标
同类平均 = 1
同领域 · 同年份 · 同类型
Google Scholar 与 OpenAlex 的被引统计范围不同,数值存在差异属正常。
AI 辅助阅读
依据:摘要
可就本文提问;依据不足时会说明。
学术脉络
学科主题
工程Tribology and Lubrication Engineering
Piezoelectric Actuators and Control · Tribology and Wear Analysis