A Pure Pulse Voltage-Based Method for Broadband Impedance Spectrum Measurement of Cables
Yaqiang Deng, Bo Zhang
State Key Laboratory of Power System Operation and Control Tsinghua University
阅读操作
确认中在文库中上传 PDF 后可生成中文音频讲解。
摘要与影响
The application of broadband impedance spectrum has become a high-performance method for localizing minor defects within cables. The primary focus of broadband impedance spectrum research has been on improving algorithms for analyzing the spectrum, with less attention given to its acquisition. Broadband impedance spectrum is typically obtained using frequency-sweeping impedance analyzers or vector network analyzers, which are often costly. In contrast to frequency-sweeping acquisition methods, this paper proposes a cost-effective, pulse voltage-based method to acquire the broadband impedance spectrum of cables by relying exclusively on measuring time-domain pulse voltages, without measuring current, under two configurations: with the cable connected to the acquisition system and with it disconnected. To enhance its applicability in practical scenarios, two correction methods are proposed to mitigate the influence of both external extension cables and internal connection cables. The experimental results demonstrate that the proposed method reliably acquires broadband impedance spectrum of cables, with a normalized root mean square error of less than 3% compared to the results obtained by impedance analyzer.
逐年被引趋势
关键指标
同类平均 = 1
同领域 · 同年份 · 同类型
Google Scholar 与 OpenAlex 的被引统计范围不同,数值存在差异属正常。
AI 辅助阅读
依据:摘要
可就本文提问;依据不足时会说明。
学术脉络
学科主题
工程Electrical Fault Detection and Protection
Advanced Electrical Measurement Techniques · Microwave and Dielectric Measurement Techniques