A New MCP-PMT Design Based on the Orthogonal Experimental Method
Chen Sun, X W Wang, Weijie Jiang, Jiacheng Zhou, Xinyu Xiao, Lin Chen, Huizhen Yang, Jianli He 等 16 位
Jinling Institute of Technology Inner Mongolia University of Science and Technology China Mobile (China)
阅读操作
确认中在文库中上传 PDF 后可生成中文音频讲解。
摘要与影响
Large-area photomultiplier tubes based on microchannel plate (MCP-PMTs) have been successfully developed in China, which have been applied in fundamental physics experiments such as the Jiangmen Underground Neutrino Observatory (JUNO), China Jin Ping underground Laboratory (CJPL) and Large High Altitude Air Shower Observatory (LHAASO). To address the design challenge of the trade-off between photoelectron collection efficiency (CE) and transit time spread (TTS), a novel large-area MCP-PMT design is proposed in this study, featuring a key separated dual-conical focusing system. A 3D simulation model was established to validate the feasibility and effectiveness of the design. Using the Finite Integration technique and the Monte Carlo method, the effects of geometric and operating parameters on CE and TTS were thoroughly investigated. The orthogonal experimental design was employed to determine the optimal set of parameters. Under the optimal configuration, the CE reaches 97.6%, and the TTS of photoelectrons traveling from the top-point of the photocathode to the MCP input face is only 1.15 ns.
逐年被引趋势
暂无年度引用数据
关键指标
同类平均 = 1
同领域 · 同年份 · 同类型
Google Scholar 与 OpenAlex 的被引统计范围不同,数值存在差异属正常。
AI 辅助阅读
依据:摘要
可就本文提问;依据不足时会说明。
学术脉络
学科主题
物理Photocathodes and Microchannel Plates
Particle Detector Development and Performance · Radiation Detection and Scintillator Technologies