Investigation of Frictional Forces in Hydraulic Spool Valves and Their Effect on the Estimation of Axial Flow Forces
Simon Hucko, Tobias Vonderbank, Katharina Schmitz
RWTH Aachen University
阅读操作
确认中在文库中上传 PDF 后可生成中文音频讲解。
摘要与影响
Model-based design of hydraulic valves, as well as the acquisition of additional variables using soft sensors are rapidly gaining importance. Both, however, require an accurate and comprehensive model of the valve. One of the greatest challenges currently present, is within correctly representing the flow forces acting on the spool, which is why considerable research has been carried out investigating them. Since flow forces are always superimposed by directional frictional, inertial, and, if present, spring forces, they cannot be measured directly. To be able to record the flow forces despite this difficulty, a new measuring method is presented. It enables the measurement of the frictional forces and thereby the calculation of the flow forces. In addition to presenting this new metrology method, the frictional force and factors influencing it, will be further investigated. These factors include the operating point-dependent non-uniform pressure distribution in the annular gap, as well as radial flow forces. The results shown in the paper contribute to a better understanding of frictional forces in hydraulic valves, thus advancing both model-based design, and soft sensor development.
逐年被引趋势
关键指标
同类平均 = 1
同领域 · 同年份 · 同类型
Google Scholar 与 OpenAlex 的被引统计范围不同,数值存在差异属正常。
AI 辅助阅读
依据:摘要
可就本文提问;依据不足时会说明。
学术脉络
学科主题
工程Hydraulic and Pneumatic Systems
Tribology and Lubrication Engineering · Fluid dynamics and aerodynamics studies