A 10Gb/s transimpedance amplifier for hybrid integration of a Ge PIN waveguide photodiode
Andreas Polzer, Wolfgang Gaberl, Robert Swoboda, Horst Zimmermann, Jean-Marc Fédéli, Laurent Vivien
TU Wien Commissariat à l'Énergie Atomique et aux Énergies Alternatives Laboratoire d'Électronique des Technologies de l'Information Université Paris-Sud
阅读操作
确认中在文库中上传 PDF 后可生成中文音频讲解。
摘要与影响
The presented paper describes a 10 Gbps optical receiver. The transimpedance amplifier (TIA) is realized in standard 0.35 μm SiGe BiCMOS technology. The main novelty of the presented design - investigated in the European Community project HELIOS - is the hybrid connection of the optical detector. The used Germanium photodetector will be directly mounted onto the receiver. A model of the relevant parasitics of the photodetector itself and the novel connection elements (micropads, metal vias and metal lines) is described. Based on this photodetector model an optical receiver circuit was optimized for maximum sensitivity at data rates in the range of 10 Gbps. The design combines a TIA and two limiting amplifier stages followed by a 50 Ω CML-style logic-level output driver. To minimize power supply noise and substrate noise, a fully differential design is used. A dummy TIA provides a symmetrical input signal reference and a control loop is used to compensate the offset levels. The TIA is built around a common-emitter stage and features a feedback resistor of 4.2 Ω. The total transimpedance of the complete receiver chain is in the range of 275 kΩ. The value of the active feedback resistor can be reduced via an external control voltage to adapt the design to different overall gain requirements. The two limiting amplifier stages are realized as differential amplifiers with voltage followers. The output buffer is implemented with cascode differential amplifiers. The output buffer is capable of driving a differential 50Ω output with a calculated output swing of 800mVp-p. Simulations show an overall bandwidth of 7.2 GHz. The lower cutoff frequency is below 60 kHz. The equivalent input noise current is 408 nA. With an estimated total photodiode responsivity of 0.5 A/W this allows a sensitivity of around - 23.1 dBm (BER = 10-9). The device operates from a single 3.3 V power supply and the TIAs and the limiting amplifier consume 32 mA.
逐年被引趋势
关键指标
同类平均 = 1
同领域 · 同年份 · 同类型
Google Scholar 与 OpenAlex 的被引统计范围不同,数值存在差异属正常。
AI 辅助阅读
依据:摘要
可就本文提问;依据不足时会说明。
学术脉络
学科主题
工程Semiconductor Lasers and Optical Devices
Radio Frequency Integrated Circuit Design · Photonic and Optical Devices