Comparison of Sn‐5Sb and Sn‐10Sb Alloys in Tensile and Fatigue Properties Using Miniature Size Specimens
Tatsuya Kobayashi, Kyosuke Kobayashi, Kohei Mitsui, Ikuo Shohji
Gunma University
阅读操作
确认中在文库中上传 PDF 后可生成中文音频讲解。
摘要与影响
Tensile and low cycle fatigue properties of Sn‐5Sb (mass%) and Sn‐10Sb (mass%) were investigated using miniature size specimens, and fracture behaviors of the specimens were observed. Tensile strength and 0.1% proof stress of both alloys decrease with increasing the temperature. The tensile strength and 0.1% proof stress of Sn‐10Sb are higher than those of Sn‐5Sb at 25°C. Elongation of Sn‐5Sb decreases with increasing the temperature except for a strain rate of 2 × 10 −1 s −1 , while Sn‐10Sb increases with increasing temperature. Although elongation of Sn‐10Sb is lower than that of Sn‐5Sb at 25°C, the difference between them is small at 150°C. Chisel‐point fracture was observed in both alloys regardless of conditions of the tensile test. The low cycle fatigue lives of Sn‐5Sb and Sn‐10Sb alloys obey the Manson–Coffin equation, and the fatigue ductility exponent, α , was 0.54 for Sn‐5Sb and 0.46 for Sn‐10Sb in the temperature range from 25°C to 150°C. On the basis of the observation of fractured specimens and the investigation of α , it was clarified that the crack progress can be delayed by the formation of coarse SbSn compounds in the Sn‐Sb alloy, and thus the fatigue properties can be improved.
逐年被引趋势
关键指标
同类平均 = 1
同领域 · 同年份 · 同类型
Google Scholar 与 OpenAlex 的被引统计范围不同,数值存在差异属正常。
AI 辅助阅读
依据:摘要
可就本文提问;依据不足时会说明。
学术脉络
学科主题
工程Electronic Packaging and Soldering Technologies
Fatigue and fracture mechanics · Metallurgical and Alloy Processes