Film Cooling in Laminar and Turbulent Supersonic Flows
M. Hombsch, Herbert Olivier
RWTH Aachen University
阅读操作
确认中在文库中上传 PDF 后可生成中文音频讲解。
摘要与影响
Film-cooling experiments of generic supersonic flat-plate flows have been conducted at the Shock Wave Laboratory, RWTH Aachen University, for the laminar and turbulent boundary-layer regimes. To obtain a cooling film, coolant is injected through different blowing geometries to the surface of the plate. The model geometry as well as the width of the blowing slots have been carefully chosen to guarantee a two-dimensional flow at the centerline. Therefore, all blowing geometries share the same width. Different injection angles and coolant mass flow rates, as well as different freestream conditions, are investigated to obtain an empirical correlation for the cooling efficiency, a value often referred to in literature that describes the cooling effect.
逐年被引趋势
关键指标
同类平均 = 1
同领域 · 同年份 · 同类型
Google Scholar 与 OpenAlex 的被引统计范围不同,数值存在差异属正常。
AI 辅助阅读
依据:摘要
可就本文提问;依据不足时会说明。
学术脉络
学科主题
工程Turbomachinery Performance and Optimization
Computational Fluid Dynamics and Aerodynamics · Heat transfer and supercritical fluids
参考文献 21
此处列出前 3 条
引用本文 73
按被引量排序,此处列出前 3 条