Feasibility Study for Feedstock Recycling on PIM Nd-Fe-B Permanent Magnets
Leonardo Ulian Lopes, Pablo Vinicius de Souza Lia Fook, Andres Owczarzak, N UEnal, T. Hartwig, Paulo A.P. Wendhausen
Universidade Federal de Santa Catarina Fraunhofer Institute for Manufacturing Technology and Advanced Materials Fraunhofer Institute for Manufacturing Technology and Advanced Materials Dresden
阅读操作
确认中在文库中上传 PDF 后可生成中文音频讲解。
摘要与影响
Powder injection molding (PIM) is a well-known process for the production of geometrically complex shaped parts at a high production rate. The possibility of recycling the raw material (feedstock) is economically necessary for industrial applications, especially when processing very expensive materials, such as rare-earth alloys. In this study, Nd-Fe-B magnets were fabricated by powder injection molding, in which the injection residues (gates, sprue and surplus green samples) were reprocessed, up to 6 times. Subsequently, samples underwent binder extraction by chemical and thermal procedures, being finally sintered under high vacuum. Physical characterizations were carried out and the magnetic properties were measured via B-H trace analysis in each batch to study the influence of the recycled feedstock on the magnetic properties of produced samples. It was concluded that the properties are significantly affected after the second reprocessing lot, mainly due to the contamination of the feedstock by organic elements by-products of the binder decomposition.
逐年被引趋势
关键指标
同类平均 = 1
同领域 · 同年份 · 同类型
Google Scholar 与 OpenAlex 的被引统计范围不同,数值存在差异属正常。
AI 辅助阅读
依据:摘要
可就本文提问;依据不足时会说明。
学术脉络
学科主题
材料 / 化学Magnetic Properties of Alloys
Powder Metallurgy Techniques and Materials · Extraction and Separation Processes